Hellraiser: Revival has some interesting puzzles tied to Genesis Configuration, and they can be confusing at first. All of them work in the same fundamental basis, but the solutions are all different.
In this guide, I will go through the correct puzzle solutions for all of them.
Table of contents
All Hellraiser: Revival Genesis Configuration Puzzles solutions
There are five Genesis Configuration puzzles to solve in Hellraiser: Revival. You can’t miss any of them since they’re all tied to the story. This also means that solving them are necessary if you want to proceed to the ending.
Sunny’s Pillar
You’ll find this puzzle during the Free Sunny’s Soul objective once you reach the end of the labyrinth ruins.
- First, rotate the square-shaped Configuration to look like a diamond.
- Next, rotate the remaining parts to resemble two parallel structures with the openings on the inside.
Hand Statue
You can solve this puzzle after receiving the Hand Statue from Bruno’s House.
- For the first side, you’ll find two boulder-like shapes parallel to each other. Rotate them until one is at the top and the other at the bottom.
- For the second side, one shape will be on the left and the other on the right.
Head Statue
You can solve this puzzle once you get the Head Statue piece from the Hand Statue unlocked area.
- For the first side, you have to make a square with the correct side on the way up (refer to the image above).
- For the second side, creating the border is slightly complex. You need to create space in the two sides and a star-shaped base in the middle. You have to rotate the gaps until they’re on the sides in both directions.
Tongue Statue
You can solve the puzzle after getting the Tongue statue piece when you finish the Well Puzzle.
- For the first side, rotate once to make it look like a diamond.
- For the second part, rotate until you see a block in all four corners.
Factory Shrine
This puzzle is one of the easiest ones to solve since it uses patterns from previous Genesis Configuration puzzles.
- For Side 1, we will just want to recreate a square and then turn it one side to resemble a diamond.
- For Side 2, use the configuration showed on the image above.
