So you want to build a LEGO Mr. Destructoid?

8:00 PM on 10.11.2009   |   SiK99

43 comments

[Editor's note: Community member SiK99 made a how to guide at making a Mr. Destructoid head out of LEGOs. Check out how to make it below! -- CTZ]

This is my attempt to compile a guide to show you the way. This build will use 103 LEGO pieces which I will list below. You can purchase all of these off the LEGO Web site by first going to "by THEME", then to "Individual Bricks & Building Accessories" and lastly to "Pick a Brick".

The grand total for the 103 pieces comes to $12.85 (not including tax/shipping). Check out the step-by-step process on how to make the Mr. Destructoid head after the break!

Legos Needed (Qty-Description-Color):

2- Round Plate 1x1- Transparent Red
2- Round Plate 1x1- Green ("Bright yellowish-green")
2- Plate 1x2- Green
4- Plate 1x2- Grey ("Medium stone grey")
1- Plate 1x3- Grey
1- Plate 1x2 W. 1 Knob- Grey
2- Plate 1x1- Grey
25- Flat Tile 1x2- Green
2- Technic Brick 1x2, 04.9- Grey
27- Plate 1x4- Green
3- Profile Brick 1x2- Grey
2- Connector Peg W. Knob- Grey
6- Brick 1x2- Green
1- Light Sword Blade- Grey
8- Brick 1x3- Green
1- 3 M.Arch W.Knob and Shaft 03.2- Grey
5- Plate 4x4- Green
5- Brick 1x4- Green
1- Brick 2x4- Green
1- Brick 1x1 W. 4 Knobs- Black(or Grey)
2- Angular Brick 1x1- Grey



Step 1:




Step 2:




Step 3:




Step 4:




Step 5:




Step 6:






Step 7:







Step 8: This one can be a bit tricky and you might have to do some adjusting later. Notice how in the fourth picture that the dark grey 4 knob piece is on the top of the vertical grey piece in such a way that allows the horizontal grey piece to "rest" in the gap. Also notice the knob on the vertical grey piece is flush with the "front". The vertical grey piece should barely be in the dark grey 4 knob piece for this to happen.






Step 9: The six Plate 1x4 Green pieces go around the top in the first picture. You then have four more of the Plate 1x4 Green pieces on top, two in front and two in back.





Step 10: The two Plate 4x4 pieces go on top.




Step 11: This step just places the Flat Tile 1x2 Green on top. I made sure to have a row connecting the two 4x4 plates below in the center to help make it sturdy. There really isn't a wrong way to do this.






Step 12: Almost done! We just have to complete the "eyebrow/nose" piece that goes on the front. You'll notice in the eighth and ninth picture that I have a pen pointing to the two pieces that are to fit together. Just put the back-middle peg into the knob and everything should line up properly.











Final Picture!

Well hopefully you were able to follow the guide without too many issues. I was going to send the LEGO Mr. Destructoid in for the "WTF is this Sh!t?" contest earlier in the year but it was ended before I had the chance. Here is a picture of the final build, the Hulk, and my DS games/tower. I'll end this by saying thanks for checking this out and I hope you enjoyed it!